Linux* Base Driver for the Intel(R) PRO/1000 Family of Adapters =============================================================== June 16, 2005 Contents ======== - In This Release - Identifying Your Adapter - Building and Installation - Command Line Parameters - Speed and Duplex Configuration - Additional Configurations - Known Issues - Support In This Release =============== This file describes the Linux* Base Driver for the Intel(R) PRO/1000 Family of Adapters, version 6.0.x. This driver supports the 2.4.x and 2.6.x kernels. This driver includes support for Itanium(R)2-based systems. This driver is only supported as a loadable module at this time. Intel is not supplying patches against the kernel source to allow for static linking of the driver. For questions related to hardware requirements, refer to the documentation supplied with your Intel PRO/1000 adapter. All hardware requirements listed apply to use with Linux. Native VLANs are now available with supported kernels. The driver information previously displayed in the /proc filesystem is not supported in this release. Alternatively, you can use ethtool (version 1.6 or later), lspci, and ifconfig to obtain the same information. Instructions on updating ethtool can be found in the section "Additional Configurations" later in this document. Identifying Your Adapter ======================== For more information on how to identify your adapter, go to the Adapter & Driver ID Guide at: http://support.intel.com/support/network/adapter/pro100/21397.htm For the latest Intel network drivers for Linux, refer to the following website. In the search field, enter your adapter name or type, or use the networking link on the left to search for your adapter: http://downloadfinder.intel.com/scripts-df/support_intel.asp Building and Installation ========================= To build a binary RPM* package of this driver, run 'rpmbuild -tb '. Replace with the specific filename of the driver. NOTE: For the build to work properly, the currently running kernel MUST match the version and configuration of the installed kernel sources. If you have just recompiled the kernel reboot the system now. RPM functionality has only been tested in Red Hat distributions. 1. Move the base driver tar file to the directory of your choice. For example, use /home/username/e1000 or /usr/local/src/e1000. 2. Untar/unzip archive: tar zxf e1000-x.x.x.tar.gz 3. Change to the driver src directory: cd e1000-x.x.x/src/ 4. Compile the driver module: make install The binary will be installed as: /lib/modules//kernel/drivers/net/e1000/e1000.[k]o The install locations listed above are the default locations. They might not be correct for certain Linux distributions. For more information, see the ldistrib.txt file included in the driver tar. 5. Install the module: insmod e1000 = 6. Assign an IP address to the interface by entering the following, where x is the interface number: ifconfig ethx 7. Verify that the interface works. Enter the following, where is the IP address for another machine on the same subnet as the interface that is being tested: ping Command Line Parameters ======================= If the driver is built as a module, the following optional parameters are used by entering them on the command line with the modprobe or insmod command using this syntax: modprobe e1000 [